Desiccant Compressed Air Dryers Made in China

Large capacity design to ensure dew point

Ensure that the alumina has a contact time of 4.8 seconds or more

30% extra absorbent to ensure its longevity

All key operating conditions are showed on PLC controller

Easy to replace the absorbent; easy to clean the stainless steel air diffuser

The layout of internal components is easy to maintain

The design of the diameter of the adsorption tower and the height of the adsorption layer is calculated after repeated demonstrations

Designed to maximize the taken away moisture and minimize air consumption

Choose Our desiccant compressed air dryer Made In China

The desiccant compressed air dryer adopts a double tower structure, one tower absorbs the moisture in the air under a certain pressure,

The other tower uses a small portion of dry air slightly higher than atmospheric pressure to regenerate the desiccant in the adsorption tower.

After a certain period of time, the two towers are switched to ensure the continuous supply of dry compressed air.

AB Absorb tower 1.2 .3. 4 Switch Valve 5.6 Check valve

7 Throttle 8 Silencer 9 Program controller

10 Pressure gauge 11 Oil remover filter 12 Dust remover filter

13. Water gas separator

*

AB Absorb tower 1.2 .3. 4 Switch Valve 5.6.7.8 Check valve

9 Throttle 10 Heater 11 Silencer

12Program controller 13 Pressure gauge 14 Oil remover filter

15 Dust remover filter 16. Water gas separator 17 Diffuser

Installation environment: no sunlight, no rain, well ventilated, installed on a horizontal hard base, no obvious dust and flies

Rated compressed air inlet temperature:	38℃, maximum 45℃
Adsorption type:	activated alumina (molecular sieve can be used for higher requirements)
Rated compressed air pressure:	0.7MPa, up to 1.0MPa
Pressure drop:	<0.021Mpa
Pressure dew point under rated conditions:	-20℃～-40℃ (molecular sieve can reach: -70℃)
Regeneration method:	normal temperature regeneration
Intake oil Content	0.08ppm (0.1mg/m)
Working mode:	two towers 4min or 10min automatic switching, continuous work
Dust particle size of finished gas:	≤ 60μm
Control mode:	cycle period 30~60min adjustable
Average reharmonization air flow:	5~8 rated processing air volume
Installation method:	indoor, no foundation installation is allowed